What it means
QNH is the air pressure setting that makes the altimeter show your altitude above sea level. Air traffic control and the ATIS give the current QNH. Pilots set it on the altimeter before takeoff and landing.[1][2][3]
Why it matters for student pilots
A wrong pressure setting means a wrong altitude, which matters most near terrain. The FAA handbook says the importance of setting the altimeter properly cannot be overemphasized.[3]
Worked example
Example: setting QNH and finding pressure altitude
The airport and its numbers are invented. The method follows the FAA handbook.[3]
- Hear it The ATIS gives QNH 1020. That is about 30.12 inches of mercury.[3]
- Set it Turn the knob until 1020 shows in the setting window.[3]
- Check it On the ground, the altimeter should now show about the field elevation, here 1,500 feet. If it is off by more than 75 feet, the FAA handbook says to have the instrument checked.[3]
- Pressure altitude Performance charts need pressure altitude. One inch of pressure is about 1,000 feet, so 1,500 feet plus (29.92 minus 30.12) times 1,000 gives 1,300 feet.[3]
- Flying on If pressure falls along your route and you keep the old setting, you fly lower than the altimeter shows. Pilots remember: from high to low, look out below.[3]
The airfield and its pressure readings are invented for this lesson.
Where you meet it in training
Before takeoff you check the altimeter against the known field elevation. In radio work, EU rules list altimeter settings among the items you must always read back.[3][7]
Common misunderstandings
How EASA, FAA and CASA differ
- FAA
- US rules use inches of mercury. Below 18,000 feet, you set the current setting of a station within 100 nautical miles of the aircraft.[4][3]
- EASA
- EU radio rules give the setting in hectopascals, spoken digit by digit. Only 1,000 hPa is said as "one thousand".[5]
- CASA
- Australian rules give QNH in hectopascals, and the transition altitude is 10,000 feet. At or below the transition altitude, you use a local QNH from within 100 nautical miles or the forecast area QNH.[6]
Try it
A few questions from the METAR trainer. No account needed, nothing is saved.
Sources
- FAA, Pilot/Controller Glossary, Q (QNH, QNE and QFE), checked 18 Nov 2026
- FAA, Pilot/Controller Glossary, F (Flight level [ICAO], note on QNH and QFE settings), checked 18 Nov 2026
- FAA, Pilot's Handbook of Aeronautical Knowledge (FAA-H-8083-25C), Chapter 8 (Flight Instruments), checked 18 Nov 2026
- eCFR, 14 CFR 91.121 (Altimeter settings), checked 18 Nov 2026
- EASA, Easy Access Rules for Standardised European Rules of the Air, SERA.14035 (Transmission of numbers in radiotelephony), checked 18 Nov 2026
- CASA, Part 91 (General Operating and Flight Rules) Manual of Standards 2020, compilation of 9 July 2026, section 11.02 (Transition altitude, transition layer and transition level), checked 18 Nov 2026
- EASA, Easy Access Rules for Standardised European Rules of the Air, SERA.8015(e) (Read back of clearances, instructions and safety-related information), checked 18 Nov 2026