What it means
IFR are the rules for flight by reference to the instruments. They let a pilot fly in clouds and in poor visibility. To act as pilot in command under IFR, you need an instrument rating.[1][3]
Why it matters for student pilots
In the United States, all flying from 18,000 feet up to FL 600 is normally IFR. Your instrument training teaches you to fly safely by the instruments alone.[8][7]
Worked example
Example: the steps of a short IFR flight in the United States
This outline follows the US rules. The flight itself is invented.[2]
- File Before you fly IFR in controlled airspace, you file an IFR flight plan.[2]
- Clearance You receive an ATC clearance and write it down, because it may differ from what you filed.[2][4]
- Read back You repeat the altitudes, headings and runway it contains, together with your callsign.[4]
- En route You fly the cleared route and altitude. You change them only with an amended clearance or in an emergency.[9]
- Arrival At the destination you fly a published instrument approach procedure to land.[7]
The outline is a simplified teaching example. It leaves out many IFR rules, such as fuel and alternates.
Where you meet it in training
IFR is the subject of the instrument rating. Its FAA test covers ATC clearances, flight by instruments alone, navigation systems and instrument approaches.[7]
Common misunderstandings
How EASA, FAA and CASA differ
- FAA
- Where no minimum altitude is published, an IFR flight stays 1,000 feet above the highest obstacle within 4 nautical miles of the course. That is about 7.4 kilometers. Over mountainous areas it is 2,000 feet.[5]
- EASA
- The EU rule applies where the State sets no minimum flight altitude. It uses 300 meters (1,000 feet) above the highest obstacle within 8 kilometers of the estimated position. Over high terrain or mountains it is 600 meters (2,000 feet).[6]
Practice it
Train it with the Abbreviations trainer in Practice, free with your account.
Abbreviations
Try it
A few questions from the Abbreviations trainer. No account needed, nothing is saved.
Sources
- FAA, Pilot/Controller Glossary, I (Instrument Flight Rules, FAA and ICAO definitions), checked 18 Nov 2026
- eCFR, 14 CFR 91.173 (ATC clearance and flight plan required), checked 18 Nov 2026
- eCFR, 14 CFR 61.3 (Requirement for certificates, ratings, and authorizations, paragraph (e)), checked 18 Nov 2026
- FAA, Aeronautical Information Manual, Chapter 4, Section 4 (4-4-7, Pilot Responsibility upon Clearance Issuance), checked 18 Nov 2026
- eCFR, 14 CFR 91.177 (Minimum altitudes for IFR operations), checked 18 Nov 2026
- EASA, Easy Access Rules for Standardised European Rules of the Air, SERA.5015(b) (Instrument flight rules, minimum levels), checked 18 Nov 2026
- FAA, Instrument Rating Airplane Airman Certification Standards (FAA-S-ACS-8C), Areas III to VI, checked 18 Nov 2026
- FAA, Aeronautical Information Manual, Chapter 3, Section 2 (3-2-2, Class A Airspace), checked 18 Nov 2026
- eCFR, 14 CFR 91.123 (Compliance with ATC clearances and instructions), checked 18 Nov 2026