Skip to main content
Aviation Connect
Log in Sign up free
An instructor and a young pilot talk at a table in a hangar, a trainer with its cowling open behind.

Aviation A to Z

Multi-Engine Rating

Last checked November 2026

What it means

A multi-engine rating lets you fly airplanes with more than one engine. Training focuses on what to do if one engine fails. The rating is added to a pilot license.[1][2][3]

Why it matters for student pilots

When one engine fails, the thrust of the working engine is uneven and pulls the airplane to one side. Training covers the two main concerns: control and climb performance.[1]

Worked example

Example: an engine fails just after takeoff in a light twin

The FAA handbook lists these typical memory items. The checklist of your own airplane always comes first.[1]

  1. Control Keep straight with rudder and hold the best single-engine climb speed, marked by a blue line on most airspeed indicators.[1]
  2. Clean up Set takeoff power and retract the flaps and landing gear.[1]
  3. Identify Dead foot, dead engine: the foot that is not pushing a rudder pedal is on the side of the failed engine.[1]
  4. Verify Pull back the throttle of the engine you think has failed. If nothing changes, you have found the right one.[1]
  5. Feather Bring that propeller control fully aft, so the blades turn edge-on to the airflow and drag drops.[1]
  6. Climb Bank about 2 degrees toward the working engine. Climb straight ahead, or with shallow turns around obstacles, to at least 400 ft above ground before you turn back.[1]

These steps summarize the handbook for learning. Always follow the checklist of the airplane you fly.

Where you meet it in training

On an FAA private pilot test in a twin, stall practice must end no lower than 3,000 ft above ground. In a single, the limit is 1,500 ft.[4]

Common misunderstandings

  • Often heard: With two engines, losing one is a small problem.

    In fact: Losing half the power cuts climb performance by 80 to 90 percent. In some light twins, climbing or even holding altitude may then be impossible.[1]

How EASA, FAA and CASA differ

EASA
Before a first single-pilot multi-engine class or type rating, you need at least 70 hours as pilot in command of airplanes.[5]
FAA
Adding the class rating needs an instructor's endorsement and a practical test. No minimum training time is set.[2]
CASA
The multi-engine airplane class rating needs a private, commercial, multi-crew or air transport license, flight training and a flight test.[3]

Practice it

Train it with the Abbreviations trainer in Practice, free with your account.

Abbreviations

Try it

A few questions from the Abbreviations trainer. No account needed, nothing is saved.

Free for students: pilot aptitude test, daily practice and school match.